Summit Audio
Would you like to react to this message? Create an account in a few clicks or log in to continue.


Pro Audio Gear for the masses
 
HomeLatest imagesSearchRegisterLog in

 

 How do I set up my ECS-410 for Voice Over (VO) work?

Go down 
AuthorMessage
Admin
Admin



Posts : 79
Join date : 2009-02-24

How do I set up my ECS-410 for Voice Over (VO) work? Empty
PostSubject: How do I set up my ECS-410 for Voice Over (VO) work?   How do I set up my ECS-410 for Voice Over (VO) work? I_icon_minitimeFri Feb 27, 2009 1:29 pm

Voice Over: turn master output level and drive level all the way down to get initial levels
TouchPatch: Pre-Dyn-EQ-DriveBus
Preamp:
Gain around 12:00, so orange LEDS just start lighting at loudest voice
Pad 0, polarity +, 48V on for condenser off for dynamic or ribbon mics
HPF off, output SS
If you hear distortion even though the meter is not lighting red, turn on the pad switch
Dynamics:
Classic mode
Gain +2
Threshold 4, so 1-3 lights on meter light
attack and release 4
EQ:
Low +3dB @ 100Hz, peaking
Mid -2dB @ 1.6KHz
High +3dB @ 12KHz shelving
DriveBus:
SS mode, output 10, turn up drive to get record level
(Variations: put dynamics in Tight mode for limiting like in radio work, bypass DriveBus for ultimate clean and quiet, use extra gain from Dynamics section if needed)
Back to top Go down
https://summit.forumotion.net
 
How do I set up my ECS-410 for Voice Over (VO) work?
Back to top 
Page 1 of 1
 Similar topics
-
» My metering stopped working on my 2BA-221, how do I get them to work again

Permissions in this forum:You cannot reply to topics in this forum
Summit Audio :: Summit Gear :: Frequently Asked Questions-
Jump to: