Pro Audio Gear for the masses
 
HomeCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 How do I set up my ECS-410 for Voice Over (VO) work?

View previous topic View next topic Go down 
AuthorMessage
Admin
Admin


Posts : 79
Join date : 2009-02-24

PostSubject: How do I set up my ECS-410 for Voice Over (VO) work?   Fri Feb 27, 2009 1:29 pm

Voice Over: turn master output level and drive level all the way down to get initial levels
TouchPatch: Pre-Dyn-EQ-DriveBus
Preamp:
Gain around 12:00, so orange LEDS just start lighting at loudest voice
Pad 0, polarity +, 48V on for condenser off for dynamic or ribbon mics
HPF off, output SS
If you hear distortion even though the meter is not lighting red, turn on the pad switch
Dynamics:
Classic mode
Gain +2
Threshold 4, so 1-3 lights on meter light
attack and release 4
EQ:
Low +3dB @ 100Hz, peaking
Mid -2dB @ 1.6KHz
High +3dB @ 12KHz shelving
DriveBus:
SS mode, output 10, turn up drive to get record level
(Variations: put dynamics in Tight mode for limiting like in radio work, bypass DriveBus for ultimate clean and quiet, use extra gain from Dynamics section if needed)
Back to top Go down
View user profile http://summit.forumotion.net
 
How do I set up my ECS-410 for Voice Over (VO) work?
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» The Rudy Vaughn Band
» God will do the work.
» Life and a Little Catch-Up
» Ponylady Will Never Work!
» Session Work has Been Disappearing - a Sign

Permissions in this forum:You cannot reply to topics in this forum
Summit Audio :: Summit Gear :: Frequently Asked Questions-
Jump to: