How do I get a great bass tone direct with my ECS-410 Everest?

Bass: turn master output level and drive level all the way down to get initial levels
TouchPatch: Pre-Dyn-EQ-DriveBus
Preamp:
Gain around 12:00, so orange LEDS just start lighting at loudest notes
Pad 0, polarity +, 48V off, HPF off, output Tube
If you hear distortion even though the meter is not lighting red, turn on the pad switch
Dynamics:
Tight mode
Gain +5
Threshold 4, so 1-3 lights on meter light
attack 2 and release 4.4
EQ try +4dB @ 630Hz, peaking, -6dB @ 18KHz
DriveBus:
tube mode, drive 8, output to recording or playing level
(Variations: send -10dB output from preamp to live bass amp for monitoring; dynamics to classic mode for less compression, lower threshold a bit; adjust drive and output level on DriveBus to get different levels of drive in tube or solid state modes)