Pro Audio Gear for the masses
HomeCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 

 How do I set up my Everest for vocals?

Go down 

Posts : 79
Join date : 2009-02-24

PostSubject: How do I set up my Everest for vocals?   Tue Feb 24, 2009 8:23 pm

Vocals: turn DriveBus master output level and drive level all the way down to get initial levels
TouchPatch: Pre-Dyn-DriveBus
Gain around 12:00, so orange LEDS just start lighting at loudest voice
Pad 0, polarity +, 48V on for condenser off for dynamic or ribbon mics
HPF on 60Hz, output tube
If you hear distortion even though the meter is not lighting red, turn on the pad switch
Classic mode
Gain +2
Threshold 4, so 1-3 lights on meter light
attack and release 4
tube mode, output 5, turn up drive to get record level
(Variations: for rap, hip-hop, hard rock and metal set compressor to Tight mode, turn DriveBus output down and Drive up until you get the amount of drive you like, all the way to distortion) cheers
Back to top Go down
View user profile
How do I set up my Everest for vocals?
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Summit Audio :: Summit Gear :: Frequently Asked Questions-
Jump to: