Pro Audio Gear for the masses
 
HomeCalendarFAQSearchMemberlistUsergroupsRegisterLog in

Share | 
 

 How do I align my meter on my MPC-100A?

View previous topic View next topic Go down 
AuthorMessage
Admin
Admin


Posts : 79
Join date : 2009-02-24

PostSubject: How do I align my meter on my MPC-100A?   Fri Feb 27, 2009 1:15 pm

In Level mode, you'll need to contact us for the alignment procedure. In GR (gain reduction) mode, take off the top of the unit and warm up completely. BE VERY CAREFUL AND TOUCH NOTHING ON THE INSIDE OF THE UNIT; POTENTIALLY LETHAL VOLTAGES INSIDE. EVEN WITHOUT POWER CONNECTED CAPACITORS WILL STORE A CHARGE THAT CAN SHOCK AND POTENTIALLY KILL. If you are unfamiliar with doing this, please have a qualified service technician do this for you. Set the meter select switch to GR. With a small, flathead screwdriver, adjust VR4 near the middle, left side of the main board until the meter rests at 0. VR4 is located in the middle of a line of 3 trim pots next to a large, black square (U5) and to the back right of the vacuum tubes. It is helpful to switch back and forth from Level to GR to make sure the meter sits in the proper position.
Back to top Go down
View user profile http://summit.forumotion.net
 
How do I align my meter on my MPC-100A?
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Odd Meter Obsessed
» Something that I did not know about
» BABY ACTION 100Q & 100A

Permissions in this forum:You cannot reply to topics in this forum
Summit Audio :: Summit Gear :: Frequently Asked Questions-
Jump to: